Jump to content
The Uniform Server Community

Let me tell you why can't a single resistor be used for many parallel LEDs


weuhfs
 Share

Recommended Posts

I have been asked for many times that why can't you use a single resistor for a number of LEDs in parallel instead of one each?

The main reason is because you can't safely connect diodes in parallel.

So when we use one resistor, we have a current limit for the whole diode section. After that it's up to each diode to control the current that goes through it.

The problem is that real world diodes don't have same characteristics and therefore there's a danger that one diode will start conducting while others won't.

By the way,you can find kinds of resistors from http://www.kynix.com/Product/Cate/84.html

So you basically want this

3FRWT.gif


And you in reality get this shCWb.gif

 

 

As you can see, in the first example, all diodes are conducting equal amounts of current and in the second example one diode is conducting most of the current while other diodes are barely conducting anything at all. The example itself is a bit exaggerated so that the differences will be a bit more obvious, but nicely demonstrate what happens in real world.

The above is written with assumption that you will chose the resistor in such way that is sets the current so that the current is n times the current you want in each diode where n is the number of diodes and that the current is actually larger than the current which a single diode can safely conduct. What then happens is that the diode with lowest forward voltage will conduct most of the current and it will wear out the fastest. After it dies (if it dies as open circuit) the diode with next lowest forward voltage will conduct most of the current and will die even faster than first diode and so on until you run out of diodes.

One case that I can think of where you can use a resistor powering several diodes would be if the maximum current going through the resistor is small enough that a single diode can work with full current. This way the diode won't die, but I myself haven't experimented with that so I can't comment on how good idea it is.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...